New Squatch Chair

[hawgrider]

Nice job beast!

[Prepared One]

The store bought ones are so cheap. This bad boy could take the weight of Whoopie Goldberg. It also has an ejector button built in should that ever happen.

I was about say, you have Whoopie over often?

[Mad Trapper]

I was about say, you have Whoopie over often?

Where is the Whoopie cushion?

[T-Man 1066]

Where is the Whoopie cushion?

Not in canada like she promised if Trump won 2016...

Stupid knappy haired libtard!!! Not even a good has-been, more like a never-was!

[Mad Trapper]

Not in canada like she promised if Trump won 2016...

Stupid knappy haired libtard!!! Not even a good has-been, more like a never-was!

That thing evolved into a full OVER grown Cape Buffalo. Years ago she looked almost human and less than 200 kilograms (440 lbs).

[T-Man 1066]

That thing evolved into a full OVER grown Cape Buffalo. Years ago she looked almost human and less than 200 kilograms (440 lbs).

You want to pick up that chick you need a friggin forklift!!

[Mad Trapper]

You want to pick up that chick you need a friggin forklift!!

Damm!!! that is a BIG forker. For a while I worked in a lumber mill and our big loader would get tipsey/front heavy, with real big logs or oversize lumber packs.

[Mad Trapper]

You want to pick up that chick you need a friggin forklift!!

Damm!!! that is a BIG forker. For a while I worked in a lumber mill and our big loader would get tipsey/front heavy, with real big logs or oversize lumber packs.

[Mad Trapper]

You want to pick up that chick you need a friggin forklift!!

You want to pick up that chick you need a friggin forklift!!

Damm!!! that is a BIG forker. For a while I worked in a lumber mill and our big loader would get tipsey/front heavy, with real big logs or oversize lumber packs.

[Inor]

Nice work on the chair!

For outdoor finish here, I have found this stuff works pretty well:

https://www.amazon.com/MESSMERs-MC-5...s%2C171&sr=8-4

It is a bit on the pricey side, but does seem to do a pretty good job protecting from the sun. (At least here, the sun is far more damaging than water).

The only thing I did a bit different than the instructions call for is to thin it out about 2:1 (2 parts finish to 1 part mineral spirits). Then I applied it with a rag instead of a brush. Wait a full 2 days for it to dry. Then do at least one more coat (preferably 2 or even 3) at full strength, drying 24 hours between coats. The full strength coats, you can use a brush.